Saltdogg 92426SSA Under Tailgate Spreader Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Pro auto Saltdogg 92426SSA Under Tailgate Spreader. SaltDogg 92426SSA Under Tailgate Spreader User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 8
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
1
TM
Instruction Manual
Direct Drive & 5:1 Gear Reduction
Under Tailgate Spreaders
UNDER TAILGATE SPREADER WARRANTY
This warranty replaces all previous warranties and no employee
of this company is authorized to extend any additional warran-
ties, or agreements, or implications not explicitly covered herein.
Buyers Products Company warrants all parts of the product to
be free from defects in material and workmanship for a period of
(1) one year from the date of original installation. Parts must be
properly installed and used under normal conditions. Normal wear
is excluded.
Any part which has been altered, including modification, misuse,
accident, or lack of maintenance will not be considered under this
warranty. Hydraulic units are not to be disassembled without
the express written permission from Buyers Products Company.
The sole responsibility of Buyers Products Company under this
warranty is limited to repairing or replacing any part(s) which
are returned, prepaid, 30 days after such defect is discovered,
and returned part(s) are found to be defective by Buyers Products
Company.
Authorization from Buyers Products Company must be obtained
before returning any part. The following information must accom-
pany defective parts returned to Buyers Products Company: RMA#,
spreader model, serial number, date installed, and distributor from
whom it was purchased. Buyers Products Company shall not be
liable for damage arising out of failure of any unit to operate prop-
erly, or failure, or delay in work, or for any consequential damages.
No charges for transportation or labor performed on any part will
be allowed under this warranty.
Table of Contents
Warranty Information ............................................... 1
Spreader Installation Instructions ........................ 1,2
Spreader Installation Drawing ................................. 2
Spinner Assembly Instructions ................................ 3
Spinner Assembly Drawing ...................................3,4
Hydraulics Installation ............................................. 4
Operating Instructions ...........................................5,6
Recommended Maintenance .................................... 6
Parts list: Spreader Assembly .................................. 7
Spreader Parts Drawing ........................................... 7
Parts List: Hardware Box ......................................... 8
Spinner Components Drawing ................................. 8
Auger Replacement Kits ........................................... 8
Installation Instructions
NOTE: The left and right end plates may, on
occasion, get bent through improper handling
during shipment or storage. If this should hap-
pen, square and true the left and right end plates
before installation.
1. Aligning the spreader:
A. Position the spreader with the truck such that
the auger drive is located on the right side of the
truck (passenger side).
B. Lift the spreader up and under the dump body
tailgate, positioning the spreader forward as close
as possible to the dump body. The tailgate of the
dump body should lay down horizontally over the
spreader.
C. Support the spreader solidly and securely when
positioning for mounting.
2. Attach mounting brackets (See hardware
installation drawing on page 2.)
A. Attach a quick detach plate, (Item 1) to both
sides of the spreader frame using hinge pins (Item
2) and a hairpin cotter pins (Item 5).
B. Position the (2) quick detach plates over the
dump body rub rails and flush with rear edge of
dump body.
C. Weld the (2) quick detach plates to the dump
body rub rails. Weld the plates continuously around
(3) sides of each plate. Do not weld along the edge
of the plates next to the attachment pin.
continued inside
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
NOTE: This manual applies to spreaders with a
top screen.
Zobrazit stránku 0
1 2 3 4 5 6 7 8

Shrnutí obsahu

Strany 1 - Instruction Manual

1TMInstruction ManualDirect Drive & 5:1 Gear Reduction Under Tailgate SpreadersUNDER TAILGATE SPREADER WARRANTYThis warranty replaces all previous

Strany 2 -

2TMD. Align the pin brace (Item 4) on the dump body using the iron brace (Item 3) for exact positioning. For proper fit, hanger iron brace may require

Strany 3

3TM3. Spinner assembly installation: (See installation drawings on pages 3 and 4.)A. Attach the spinner shield (Item 2) to the spinner frame (Item 1)

Strany 4 - ITEM PART NO. QTY DESCRIPTION

4TM32185674Hydraulic Installation InstructionsA. During assembly take precautions to keep all hydraulic components as clean as possible.B. Allow enoug

Strany 5 - Operating Instructions

5TMAuger Quick Disconnect InstallationOperating Instructions1. Pre-start up.A. Use high grade non foaming hydraulic oil to fill reservoir about 3/4 ful

Strany 6 - Recommended Maintenance

6TM3. Using the Auger Lock-out SystemA. Shut off spinner and auger then position the main hydraulics on/off lever to off. Turn off truck.B. Verify hyd

Strany 7 - Bill of Materials

7TMUSED ON92421SSA & 92426SSALEFT SIDE DISCHARGE MODELSLEFT SIDE DISCHARGE MODELSGEARBOX PARTS (92430SSA ONLY)USED ON DIRECT DRIVE MODELS ONLYFRAM

Strany 8

8TM 1 2 3 6 7 4 5 8 9 11 2 5 6 7 4 3 8 9 10 1 12 3026614 Rev. ABill of MaterialsITEM PART NO. QTY DESCRIPTION1924F00811 Auger Stand

Komentáře k této Příručce

Žádné komentáře